Instructions for Self-Cleaning the Filters and Tank of a Home Reverse Osmosis System
Read more
Aaj Tak
www.aajtak.in

Instructions for Self-Cleaning the Filters and Tank of a Home Reverse Osmosis System

Water purifiers installed in homes provide a daily supply of clean and healthy water. However, with constant use, dirt, bacteria, and green mold begin to accumulate in the water storage tanks and filters. This mold not only worsens the taste and smell of the water but can also contaminate it, causing digestive problems.

Furthermore, dirt buildup in the filters increases the load on the reverse osmosis (RO) system, leading to its premature failure. To keep your water purifier in like-new condition and receive clean water for many years, it is crucial to regularly clean its filters and tank.

Necessary Cleaning Supplies

For cleaning, you will need the following items: one cup of white vinegar or lemon juice, two tablespoons of baking soda, warm water, a clean sponge or soft brush, and dish soap.

Cleaning Procedure

Before starting the cleaning process, you must switch off the main power switch of the RO system and completely turn off the water supply tap. Then, open the RO tap to drain all the water accumulated in the storage tank.

Next, open the top cover of the RO system. Mix one cup of vinegar and two tablespoons of baking soda to prepare a paste. Apply this paste to the walls of the tank where mold and yellow stains have formed, using a sponge. Leave the paste on for ten minutes, then thoroughly wipe the surface with a soft sponge.

For disinfection, fill the tank with warm water, adding half a cup of vinegar, and leave it for fifteen minutes to destroy all bacteria and eliminate odors. After this, completely drain the water from the tank.

The next step is to clean the transparent pre-filter housing located outside the RO system. Open this housing, remove the cartridge/filter, and rinse it under clean warm water, removing settled dirt. If the filter looks too dark or old, it should be replaced.

After all components have been reassembled, turn on the water supply and let all the water from the filled tank run out for the first time. The water in the second tank after this will be absolutely clean and safe to drink.

Similar stories

Ways to clean a cooler from mold and odor during the rainy season
Read more
www.aajtak.in

Ways to clean a cooler from mold and odor during the rainy season

During the summer and rainy season, air coolers provide coolness, but with the start of the rains, an unpleasant smell of rot, dampness, and mold often appears from the cooler. Due to increased humidity in the monsoon season, bacteria, mold, and algae begin to develop very quickly in the tank and on the cooler's leaves. When the cooler is running, this contaminated and smelly air spreads throughout the room, which not only makes breathing difficult but also increases the risk of illness.

If you are concerned about the unpleasant odor from your cooler during the rainy season, you can quickly eliminate this problem using a special item you have at home, without using expensive chemical agents. Below are simple tricks and other effective methods.

First, you need to completely empty the cooler: unplug it and remove all dirty water from the tank. Then, apply white vinegar or spray vinegar diluted with water onto the inner surfaces and corners of the tank. Leave the vinegar for one hour, after which carefully remove the mold and accumulated residue using an old brush or scraper. After this, the tank should be thoroughly rinsed with clean water two or three times to remove all dirt and odor. To prevent the re-development of bacteria and mold, add a piece of alum to the tank after filling it with clean water.

To combat odors, you can use baking soda and neem oil: add two tablespoons of baking soda and 8–10 drops of neem oil or camphor to the cooler reservoir. Baking soda instantly absorbs the smell of rot and mold growing in the water, while neem oil destroys bacteria and mosquito larvae. You can also prepare a spray from vinegar and alum: mix 2 tablespoons of white vinegar and a little alum in a spray bottle with 1 liter of water and spray it on the cooler's leaves or felt panels. This will eliminate mold and fungus on the panels, as well as get rid of the odor.

Another useful trick is the use of alum: adding a small piece of alum to the cooler tank helps settle dirt contained in the water. Alum purifies the water and makes it free of bacteria, thus stopping the appearance of a musty odor. Furthermore, during the rainy season, it is recommended to change the water every 2–3 days instead of waiting a whole week; you must drain the old water, dry the tank thoroughly, and pour in fresh water. When filling the tank, you can add a few drops of lemongrass, eucalyptus, or lavender essential oils so that a fresh and pleasant aroma spreads in the room when the cooler is running.

Tips for Cleaning Wet Carpets: How to Clean and Freshen a Carpet After the Rain
Read more
www.aajtak.in

Tips for Cleaning Wet Carpets: How to Clean and Freshen a Carpet After the Rain

During the rainy season, driving around and enjoying hot tea with snacks are pleasant activities, but this period also brings dirt. Carpets laid on the floor of a house become dirty very quickly after people come in from outside. Expensive and heavy carpets can easily get wet and soiled during the rain, which looks very unsightly.

Due to wet shoes brought in from outside, traces of dirt, mud, and water remain on the carpet. Sometimes the carpet becomes completely soaked. If it is not cleaned and dried in a timely manner, a musty smell can appear, and the risk of bacteria and mold proliferation increases. Nevertheless, several simple home methods can easily clean a wet and dirty carpet.

If the carpet is heavily soaked due to rain, you should absolutely not start scrubbing it immediately. This can cause dirt and debris to penetrate deeper into the carpet fibers. First, you should use dry towels or a clean cloth to press down and absorb the water from the surface of the carpet. Instead of rubbing, gently press the carpet with the cloth.

The carpet gets dirty and damp from dirty shoes and feet, causing an unpleasant odor. To combat this smell, baking soda, which is used in the kitchen, can be employed. After the carpet has dried as much as possible, sprinkle a layer of baking soda on it and leave it for several hours. Baking soda is capable of absorbing moisture and odors. Then, the carpet should be thoroughly vacuumed.

Spots often appear on the carpet, whether they are soil or traces of tea and coffee. To remove these light stains, you can prepare a solution by mixing a little liquid dish soap, water, and white vinegar in a bowl. Before applying this solution to the entire carpet, be sure to test it on a small, inconspicuous area to ensure it does not damage the color. If the color is unaffected, carefully apply the solution to the stain with a clean cloth, and then blot the excess with a dry cloth.

After cleaning, it is crucial to ensure the carpet dries completely. Therefore, it should be spread out in a well-ventilated area or placed under the airflow of a fan. If the carpet is left wet for a long time during the rainy season, it can worsen the musty odor problem.

Since the composition of each carpet fabric differs, a test dyeing should be conducted on a small area before using any home remedy. If the carpet is very expensive, fragile, or has been in a wet state for a long time, it is better to consult professional cleaners.

Popular